T-GPPS 1460 is a GPPS grade intended for applications including All mentioned data are typical values and not to be construed as real specifications. Users should confirm results through their tests. For more information about guaranteed items, please refer to S.S.S. (Standard Sales Specifications).; Density and shrinkage of this grade are approximately around 1.04 kg/lit & (0.4-0.7)% (ASTM D-955) respectively.. Review the listed technical properties and confirm current specifications, regulatory suitability and availability with the relevant supplier before purchase.
Representative disclosure:
Applications
- All mentioned data are typical values and not to be construed as real specifications. Users should confirm results through their tests. For more information about guaranteed items, please refer to S.S.S. (Standard Sales Specifications).
- Density and shrinkage of this grade are approximately around 1.04 kg/lit & (0.4-0.7)% (ASTM D-955) respectively.
- All tests are carried out at 23°C, unless otherwise specified.
- If the injection molding products quality is affected by moisture, GPPS granules can be dried at 70°C for 2-4 hours.
Technical properties
Technical values are source-captured and pending confirmation against current supplier documentation.
| Property | MELT FLOW INDEX (200°C 5KG) | Unit | g/10min | Test Method | ASTM D-1238 | Typical Value | 6.5 |
|---|---|---|---|---|---|---|---|
| Property | STYRENE RESIDUAL MONOMER | Unit | PPM | Test Method | CLG LABPSG004 (ATOFINA TEST METHOD) | Typical Value | <500 |
| Property | VICAT SOFTENING POINT (50°C/hr 1kg) | Unit | °C | Test Method | ASTM D-1525 | Typical Value | 103 |
| Property | TENSILE STRENGTH AT BREAK | Unit | MPA | Test Method | ASTM D-638 | Typical Value | 48 |
| Property | ELONGATION AT BREAK | Unit | % | Test Method | ASTM D-638 | Typical Value | 1 |
| Property | TENSILE MODULUS | Unit | MPA | Test Method | ASTM D-638 | Typical Value | 3200 |